Image 1

Take out your Filmsticks Clapper Sticks, the Acrylic Board Slate and Tape. You will require scissors and a cutting knife for the tape

Image 2 & 3

Measure the Tape length so that it is almost the width of the Slate, using your fingers as a guide to leave space at the end of the Slate (so the Tape cannot be seen at the ends when the Clapper Stick is attached).

Image 4 & 5

Apply the Tape to the top of the Slate in the manner shown. The Tape should be able to fold completely over to the back side of the Slate and ensure a smooth finish. Depending on the width of the Slate, you may find that the process in Image 3, 4, 5 is repeated, adding another layer of tape to both sides until the Slate fits snugly into the Sticks.

Image 6

Apply the square pieces of Tape onto the Slate as shown in the image.

Image 7 & 8

Fold the Square pieces of Tape over the Slate.

Image 9 & 10

Take the Slate and the Sticks and press the Sticks onto the Slate as shown in the image.

Image 11

The Sticks should fit snugly onto the Slate

Image 12 & 13

Push down on the Sticks to ensure that they are firmly in place, and you can turn the Clapperboard upside down to push the Slate to ensure

Image 14, 15 & 16

Next, you may see some unwanted Tape showing on the Clapperboard. To remove this, take your sharp Knife, and Score the Tape gently (so as not to cut too deep and scratch 

Image 17 & 18

At the end of this process, the result should be that you cannot see Tape underneath the Sticks. Now your Clapperboard is perfectly set up and ready for use.

Image 19

Place your Filmsticks Clapperboard into the Cover to protect your slate, and your ready to go!